...
| Info |
|---|
On Unix-like systems you may need to preface zerotier-cli commands with sudo, while on Windows you will need to use an administrator-mode command prompt. |
Using zerotier-cli
Get your ZeroTier address and check the service status
| Code Block | ||
|---|---|---|
| ||
zerotier-cli status |
200 info 998765f00d 1.2.13 ONLINE
Join, leave, and list networks. Remember, ZeroTier networks are 16-digit IDs that look like 8056c2e21c000001
| Code Block | ||
|---|---|---|
| ||
zerotier-cli join ################ |
...
200 listnetworks 8056c2e21c000001 earth.zerotier.net 02:99:35:84:f9:dc OK PUBLIC 29.152.27.109/7
List Networks Output:
OK
You're up and running on this network!
Requesting Configuration
Negotiating with the network Controller. This could take about a minute. If it takes much longer, see Router Configuration Tips.
Not Found
Typo in the Network ID?
Access Denied
You node needs to be Authorized on this network (via my.zerotier.com). Talk to you friendly network administrator.
Port Error
Something went wrong with the ZeroTier installer.
...
On Linux, make sure the tun driver is loaded.
“missing authentication token and authtoken.secret not found (or readable)”
If you get this error message, you’re likely trying to run zerotier-cli from a non-administrative account. On macOS, Linux, or other Unix based systems, use sudo zerotier-cli. On Windows, use an Administrator Command Prompt.
Related articles
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...